室内几何条件对土壤高光谱数据波动性的影响

利用方差分析方法,研究了光源照射角度、探头距离、光源距离等3个测试几何条件对室内土壤高光谱数据波动性的影响,并探讨了其物理机理.结果表明,探头距离对室内高光谱样本曲线的波动性影响不明显,而光源照射角度、光源距离对室内高光谱样本曲线波动性影响在所有的研究波段都达到了极显著水平;两个因素之间的交互作用的显著性与因素和波段有关.3个因素间的交互作用不显著.在本试验研究条件下,15°的光源照射角度、15cm的探头距离和30cm的光源照射距离是最理想的室内测试几何条件组合.     

复杂非线性电阻电路小信号分析法的研究

利用小信号分析法，对复杂线性电阻网络与数个非线性电阻元件联接的电路进行了分析求解，进而得出了复杂非线性电阻电路的一般分析方法。     

Phenotypic effects of antibiotic‐induced axenity and egg disinfection in early larval European seabass (Dicentrarchus labrax L.)

In the present study, the hypothesis that the difference in axenic conditions in the incubation and rearing environment of European seabass larvae induces size and shape effects on the specimens is tested. This difference is studied between xenic and axenic seabass larvae of DAH (day after hatching) 0, 5, 11 and 15. The axenic rearing protocol involves an egg disinfection with glutaraldehyde after the primary one with iodine in the hatchery, and the hypothesis that this secondary disinfection induces size and shape effects is also tested. In order to accomplish this, three egg and larvae treatments are included: “DA” (disinfected axenic), “DX” (disinfected xenic) and “NX” (nondisinfected xenic). Regarding the effect of antibiotic‐induced axenity, DA larvae exhibited larger bodies than both DX and NX on DAH 5 and 11. They also had a smaller yolk sac than DX at hatching, but consumed it slower. Towards the end of the experiment, DA larvae were thicker, but slightly more curved than DX and NX, which may be an abnormal shape, or a slightly more advanced ontogenetic stage. As far as egg disinfection, it had significant but very moderate shape effects on DAH 5 and 11, and disinfected larvae consumed their yolk sac faster. To the best of our knowledge, this study is one of the first to illustrate the subtle but significant size and shape effects caused by antibiotic‐induced axenity and secondary egg disinfection in the early larval stages, which suggest the existence of bacterial mechanisms that play a phenotypic role.     

Quantifying growth in maricultured corals using photogrammetry

In coral mariculture, growth is one of the most common ways to track success. However, numerous methods of monitoring coral growth make comparative studies challenging. A literature review of 39 studies from 1982 to 2017 indicated that the most predominant non‐invasive methods used were linear and areal measurement and these were evaluated for their accuracy using nursery‐reared corals. The monthly change in linear and areal growth rates of six coral species (n = 215), Pocillopora acuta, Hydnophora rigida, Merulina ampliata, Podabacia crustacea, Echinopora lamellosa and Platygyra sinensis were measured via photogrammetry. We tested whether the planar area of coral colonies can be estimated using three geometric formulas of linear measurements. Based on the literature review, the six types of measurement methods were namely linear, volume, weight, area, count of polyps/branches and calcification, in decreasing order of application. Our results showed that the change in area calculated by geometric mean diameter (GMD) formulas provided the most accurate estimation among the three formulas and was strongly correlated with planar area (R² ≥ .60; p < .05) for all coral species, except E. lamellosa and Pl. sinensis. However, our findings suggest that it is not ideal to use geometric formulas to estimate the change in area. Instead, we posit that areal photogrammetry represents the simplest yet accurate non‐invasive method for rapid monitoring of extensive areas of corals in situ. Lastly, we discuss the recommendations and limitations for areal photogrammetry.     

MODIS遥感影像的几何精校正--以阿勒泰地区为例

遥感资料的准备和处理是遥感技术在实际应用中的核心工作,几何精校正是利用地面控制点(GCP)对遥感影像进行的几何校正。研究在对阿勒泰地区草地监测时用ERDAS IMAGINE软件对MODIS资料进行几何精校正,主要对相关模型参数设置、控制点输入和几何精校正作了探讨。结果表明:影响几何精校正的因素,主要表现在GCP的数量、分布和定位精度及校正方法和重采样方法。     

钢筋混凝土框架柱计算长度设计方法研究

首先采用直接由材料本构关系形成单元M-N-Φ本构矩阵的方法推导出钢筋混凝土构件的单元刚度矩阵，编制了可以同时考虑材料和几何双重大量线性影响的有限元程序，与独立柱和框架柱的试验结果相比，计算结果吻合较好；然后，采用该分析程序对一榀二跨七层的规则框架算例进行分析，计算了各柱单元控制截面的二阶弯矩，并分析了二阶弯矩随各影响因素的变化规律；最后，以现行设计规范中标准柱偏心距增大系数的原型公式在本研究程序条件下修正公式为基点，分析了所选算例各柱单元的计算长度随各影响因素的变化规律。     

精密镗床旋转轴几何误差完备性测量与辨识

针对四轴卧式镗床旋转轴需测几何误差的数目不统一与完备性缺失的问题,提出了基于形状创成函数的四轴卧式镗床旋转轴PIGEs形成机理分析方法与旋转轴完备几何误差测量辨识方法。基于形状创成机理构建了卧式镗床几何误差创成函数,确定了旋转轴可通过误差补偿进行调整的最少与位置无关的几何误差(Position-independent geometric error, PIGEs)数目。建立了卧式镗床旋转轴4项PIGEs、6项与位置有关的几何误差(Position-dependent geometric error, PDGEs)、6项安装误差(Setup error, SEs)与球杆仪(Double ball bar, DBB)测量轨迹半径之间的完备性函数模型,设计了基于DBB的四轴联动Viviani曲线测量轨迹,构建了旋转轴6项PDGEs的NURBS表征与PIGEs、SEs辨识方法。开展了误差补偿对比实验验证,结果表明,利用几何误差完备性测量与辨识结果进行误差补偿,较仅单一补偿6项PDGEs可提升圆轨迹测量精度40.69%。     

Characterizing Spatial Variability of Soil Textural Fractions and Fractal Parameters Derived from Particle Size Distributions

Soil particle size distribution (PSD) is a fundamental physical property affecting other soil properties. Characterizing spatial variability of soil texture is very important in environmental research. The objectives of this work were: 1) to partition PSD of 75 soil samples, collected from a flat field in the University of Guilan, Iran, into two scaling domains using a piecewise fractal model to evaluate the relationships between fractal dimensions of scaling domains and soil clay, silt, and sand fractions and 2) to assess the potential of fractal parameters as an index used in a geostatistical approach reflecting the spatial variability of soil texture. Features of PSD of soil samples were studied using fractal geometry, and geostatistical techniques were used to characterize the spatial variability of fractal and soil textural parameters. There were two scaling domains for the PSD of soil samples. The fractal dimensions of these two scaling domains (D₁ and D₂) were then used to characterize different ranges of soil particle sizes and their relationships to the soil textural parameters. There was a positive correlation between D₁ and clay content (R² = 0.924), a negative correlation between D₁ and silt content (R² = 0.801), and a negative correlation between D₂ and sand content (R² = 0.913). The geometric mean diameter of soil particles had a negative correlation with D₁ (R² = 0.569) and D₂ (R² = 0.682). Semivariograms of fractal dimensions and soil textural parameters were calculated and the maps of spatial variation of D₁ and D₂ and soil PSD parameters were provided using ordinary kriging. The results showed that there were also spatial correlations between D₁ and D₂ and particle size fractions. According to the semivariogram models and validation parameters, the fractal parameters had powerful spatial structure and could better describe the spatial variability of soil texture.     

豫东南沙地4种人工林土壤团聚体稳定性及有机碳分布研究

为探究林分类型对土壤团聚体稳定性及有机碳分布特性的影响,以豫东南沙地4种典型人工林(桂花、合欢、栾树和女贞)为研究对象,通过野外调查、取土壤样品和室内试验对土壤团聚体和有机碳进行测定、分析。结果表明,①4种林分类型下土壤大团聚体(>0.25mm)含量最高,占林地土壤总团聚体的69.63%%~97.30%,粒径0.25~0.15mm团聚体含量最低,且不同林分类型下各层土壤团聚体的质量分数呈现不同的差异。②表层(0~10cm)土壤团聚体平均质量直径(MWD)、几何平均直径(GMD)均表现为栾树>合欢>桂花>女贞,分形维数(D)排序则与之相反,变化范围为2.515~1.653,栾树的土壤结构稳定性最强。③随土壤团聚体粒径的减小,4种林分土壤有机碳含量总体上呈现先升后降趋势,土壤剖面上也表现出随土层加深而下降。不同林分类型下,土壤有机碳含量差异性表现为合欢最高,栾树最低,变化范围分别为45.76~7.65和17.78~3.49g/kg。④回归分析表明,女贞林分下土壤大团聚体与有机碳含量相关性最强,土壤有机碳可解释17.5%土壤大团聚体含量的变化。研究得出该地区栾树林下土壤团聚体稳定性较强,合欢林下土壤有机碳含量最高。     

基于微分几何与EDEM的船型开畦沟装置触土曲面优化

针对长江中下游地区油菜种植时土壤黏重板结、含水率波动大、播种作业需开畦沟避免渍害的农艺要求,考虑开沟犁体的触土曲面复杂、难以通过高速数字化土槽及田间试验方法寻求其减阻设计方法和理论依据的问题,采用微分几何理论并结合EDEM仿真方法,开展了驱动圆盘犁对置组合式耕整机开畦沟装置主要触土曲面结构优化研究。通过对主要触土曲面(开畦沟前犁犁体曲面、船式开沟犁整形曲面)牵引阻力分析和曲面参数分析,确定了触土曲面主要结构参数范围。根据微分几何理论,分别建立了能量化描述不同导曲线类型(直线、抛物线、指数曲线)犁体曲面形状变化差异的微分内蕴几何量E、L、M表达式。阻力特性仿真试验结果表明:在作业速度为0. 9～1. 5 m/s、曲面结构参数一定时,导曲线为抛物线型的开畦沟前犁和船式开沟犁具有较好的减阻特性,其平均牵引阻力相比直线型犁体分别低15. 09%、16. 92%,相比指数线型犁体分别低32. 59%、31. 58%。触土曲面的内蕴几何量E、L、M可分别反映犁体阻力随速度的增长速率、犁体牵引阻力大小、犁体阻力随速度的波动程度。当设计犁体的导曲线形状使曲面内蕴几何量E的变化率较小、L为单调减函数、M的波动较小时,犁体具有较好的减阻性能。参数优化仿真试验表明:在作业速度为1. 2 m/s、抛物线型开畦沟前犁宽度为92 mm、船式开沟犁整形曲面最大元线角为66°时,开畦沟装置牵引阻力最小,为1 042. 52 N。田间试验表明:经参数优化的组合式船型开畦沟装置在作业速度为0. 9、1. 2、1. 5 m/s时测试的平均牵引阻力分别为956. 77、1 101. 33、1 564. 85 N,与仿真试验结果误差在7%以内,作业效果满足油菜播种开畦沟的农艺要求。